If you want any additional information about the state of the UPS, or additional control over its functionality, you need to install the PowerChute software and connect the unit to a computer via USB. The BE600M1 doesn’t have a display, and the LED indicators are limited to a fairly bright light that indicates the unit is powered on. You can use the UPS as it stands without connecting it to a computer, although there is some more setup work involved if you decide to install the PowerChute software. Once the battery is plugged in and the unit is charged, it’s technically ready to go. I was able to jostle it loose by tapping the entire unit on my desk, but it’s easy to see a situation where needle nose pliers might be required to coax the cable out. The potential issue comes from the positive battery cable, which was tucked away deep inside my test unit. The battery compartment cover slides off easily, and the battery itself also pops out without issue. It’s a minor inconvenience, but your mileage will vary depending on how much trouble you have fishing out the positive battery lead. The BE600M1 comes with the battery disconnected for what I assume are safety reasons, although I’ve used plenty of UPS units that come already plugged in and ready to go. Initial Setup: Hooking up the battery is a little tricky The outlets are all easy to reach, and the unit can fit nicely on an end table or bookshelf if you aren’t using it at your computer desk. I use the older BGE90M to power networking equipment, and I found that the slightly larger BE600M1 fit nicely into the same space during the time I spent testing it. With the included software, and a connection using the USB-B port, you can monitor power levels and change settings like how and why the alarm will go off.įor smaller UPS devices like this one, this is my preferred form factor. This unit includes an additional connection in the form of a USB Type B port, which is located on the same side as the power cable and circuit breaker, and meant for interfacing with a computer. The power button and single USB port are also on top, albeit on a slightly lower level than the outlets. It’s taller than it is wide, and longer than it is tall, with all the power outlets arranged in a row on top. The APC Back-UPS BE600M1 has the same toaster-like form factor as the older BGE90M that I’ve been using for years and a matte black finish unlike the semi-gloss white finish of the older unit. Lifewire / Jeremy Laukkonen Design: Compact vertical design doesn’t get in the way
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |